How to Install Weed Cutting Discs

Introduction

• Weed cutting discs are two convex discs designed for early-stage weeding.
• They work by loosening the soil and uprooting weeds, especially where crusts form.
• Only installed on passive trailers.

Caution

• Before ordering, state the row distance:

109011038R00: 250 mm trailer distance (fits 500 mm & 250 mm spacing).

109011027R00: 225 mm trailer distance (fits 450 mm spacing).

• Tool beams must be 125 mm left of the seeding engraving.
• Adjust discs for depth, spacing, and pitch depending on crop size and field conditions.
• If mounted, adjust or remove the weeding wire so it doesn’t run over the crop.

How to Install

Step 1 – Remove the front plow and front wheel from the passive trailer.

Step 2 – Keep the front plow bolt in place, tighten slightly with the flange nut.

Step 3 – Reassemble the front wheel using the supplied bolt and washers.

Step 4 – Remove two 6 mm bolts, then mount the bushing and steel washer by the wheel.

Step 5 – Install the new bracket with the supplied 6 mm bolts on the top part.

Step 6 – Tighten the nut fixing the bracket to the front wheel.

Step 7 – Insert the weed cutting disc arm into the support bracket.

Step 8 – Use the 10 mm bolts to secure the assembly and adjust working depth.